| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the dynamic access control list (ACL) feature of Cisco IOS XE Software running on Cisco Catalyst 4000 Series Switches could allow an unauthenticated, adjacent attacker to cause dynamic ACL assignment to fail and the port to fail open. This could allow the attacker to pass traffic to the default VLAN of the affected port. The vulnerability is due to an uncaught error condition that may occur during the reassignment of the auth-default-ACL dynamic ACL to a switch port after 802.1x authentication fails. A successful exploit of this issue could allow a physically adjacent attacker to bypass 802.1x authentication and cause the affected port to fail open, allowing the attacker to pass traffic to the default VLAN of the affected switch port. Cisco Bug IDs: CSCvc72751. |
| A vulnerability in the General Packet Radio Service (GPRS) Tunneling Protocol ingress packet handler of Cisco ASR 5500 System Architecture Evolution (SAE) Gateways could allow an unauthenticated, remote attacker to cause a partial denial of service (DoS) condition on an affected device. The vulnerability is due to improper input validation of GPRS Tunneling Protocol packet headers. An attacker could exploit this vulnerability by sending a malformed GPRS Tunneling Protocol packet to an affected device. A successful exploit could allow the attacker to cause the GTPUMGR process on an affected device to restart unexpectedly, resulting in a partial DoS condition. If the GTPUMGR process restarts, there could be a brief impact on traffic passing through the device. Cisco Bug IDs: CSCve07119. |
| A vulnerability in the handling of IP fragments for the Cisco Small Business SPA300, SPA500, and SPA51x Series IP Phones could allow an unauthenticated, remote attacker to cause the device to reload unexpectedly, resulting in a denial of service (DoS) condition. The vulnerability is due to the inability to handle many large IP fragments for reassembly in a short duration. An attacker could exploit this vulnerability by sending a crafted stream of IP fragments to the targeted device. An exploit could allow the attacker to cause a DoS condition when the device unexpectedly reloads. Cisco Bug IDs: CSCve82586. |
| IBM Tivoli Endpoint Manager (IBM BigFix Platform 9.2 and 9.5) does not perform an authentication check for a critical resource or functionality allowing anonymous users access to protected areas. IBM X-Force ID: 123862. |
| A vulnerability in the ROM Monitor (ROMMON) code of Cisco IR800 Integrated Services Router Software could allow an unauthenticated, local attacker to boot an unsigned Hypervisor on an affected device and compromise the integrity of the system. The vulnerability is due to insufficient sanitization of user input. An attacker who can access an affected router via the console could exploit this vulnerability by entering ROMMON mode and modifying ROMMON variables. A successful exploit could allow the attacker to execute arbitrary code and install a malicious version of Hypervisor firmware on an affected device. Cisco Bug IDs: CSCvb44027. |
| A vulnerability in the ability for guest users to join meetings via a hyperlink with Cisco Meeting Server could allow an authenticated, remote attacker to enter a meeting with a hyperlink URL, even though access should be denied. The vulnerability is due to the incorrect implementation of the configuration setting Guest access via hyperlinks, which should allow the administrative user to prevent guest users from using hyperlinks to connect to meetings. An attacker could exploit this vulnerability by using a crafted hyperlink to connect to a meeting. An exploit could allow the attacker to connect directly to the meeting with a hyperlink, even though access should be denied. The attacker would still require a valid hyperlink and encoded secret identifier to be connected. Cisco Bug IDs: CSCve20873. |
| A vulnerability in the Cisco Network Plug and Play application of Cisco IOS 12.4 through 15.6 and Cisco IOS XE 3.3 through 16.4 could allow an unauthenticated, remote attacker to gain unauthorized access to sensitive data by using an invalid certificate. The vulnerability is due to insufficient certificate validation by the affected software. An attacker could exploit this vulnerability by supplying a crafted certificate to an affected device. A successful exploit could allow the attacker to conduct man-in-the-middle attacks to decrypt confidential information on user connections to the affected software. Cisco Bug IDs: CSCvc33171. |
| A vulnerability in the web-based user interface (web UI) of Cisco IOS XE 16.2 could allow an authenticated, remote attacker to elevate their privileges on an affected device. The vulnerability is due to incorrect default permission settings for new users who are created by using the web UI of the affected software. An attacker could exploit this vulnerability by using the web UI of the affected software to create a new user and then logging into the web UI as the newly created user. A successful exploit could allow the attacker to elevate their privileges on the affected device. This vulnerability affects Cisco devices that are running a vulnerable release Cisco IOS XE Software, if the HTTP Server feature is enabled for the device. The newly redesigned, web-based administration UI was introduced in the Denali 16.2 Release of Cisco IOS XE Software. This vulnerability does not affect the web-based administration UI in earlier releases of Cisco IOS XE Software. Cisco Bug IDs: CSCuy83062. |
| A vulnerability in the implementation of the Locator/ID Separation Protocol (LISP) in Cisco IOS XE 3.2 through 16.5 could allow an unauthenticated, remote attacker using an x tunnel router to bypass authentication checks performed when registering an Endpoint Identifier (EID) to a Routing Locator (RLOC) in the map server/map resolver (MS/MR). The vulnerability is due to a logic error introduced via a code regression for the affected software. An attacker could exploit this vulnerability by sending specific valid map-registration requests, which will be accepted by the MS/MR even if the authentication keys do not match, to the affected software. A successful exploit could allow the attacker to inject invalid mappings of EIDs to RLOCs in the MS/MR of the affected software. This vulnerability affects Cisco devices that are configured with LISP acting as an IPv4 or IPv6 map server. This vulnerability affects Cisco IOS XE Software release trains 3.9E and Everest 16.4. Cisco Bug IDs: CSCvc18008. |
| A vulnerability in the Cisco Unified Computing System (UCS) Manager, Cisco Firepower 4100 Series Next-Generation Firewall (NGFW), and Cisco Firepower 9300 Security Appliance could allow an authenticated, local attacker to obtain root shell privileges on the device, aka Command Injection. The vulnerability is due to improper validation of string input in the shell application. An attacker could exploit this vulnerability through the use of malicious commands. A successful exploit could allow the attacker to obtain root shell privileges on the device. Cisco Bug IDs: CSCvf20741, CSCvf60078. |
| A vulnerability in the detection engine parsing of IPv6 packets for Cisco Firepower System Software could allow an unauthenticated, remote attacker to cause high CPU utilization or to cause a denial of service (DoS) condition because the Snort process restarts unexpectedly. The vulnerability is due to improper input validation of the fields in the IPv6 extension header packet. An attacker could exploit this vulnerability by sending a malicious IPv6 packet to the detection engine on the targeted device. An exploit could allow the attacker to cause a DoS condition if the Snort process restarts and traffic inspection is bypassed or traffic is dropped. This vulnerability is specific to IPv6 traffic only. This vulnerability affects Cisco Firepower System Software Releases 6.0 and later when the software has one or more file action policies configured and is running on any of the following Cisco products: 3000 Series Industrial Security Appliances (ISR), Adaptive Security Appliance (ASA) 5500-X Series with FirePOWER Services, Adaptive Security Appliance (ASA) 5500-X Series Next-Generation Firewalls, Advanced Malware Protection (AMP) for Networks, 7000 Series Appliances, Advanced Malware Protection (AMP) for Networks, 8000 Series Appliances, FirePOWER 7000 Series Appliances, FirePOWER 8000 Series Appliances, Firepower Threat Defense for Integrated Services Routers (ISRs), Firepower 2100 Series Security Appliances, Firepower 4100 Series Security Appliances, Firepower 9300 Series Security Appliances, Virtual Next-Generation Intrusion Prevention System (NGIPSv) for VMware. Cisco Bug IDs: CSCvd34776. |
| A vulnerability in SSL traffic decryption for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause depletion of system memory, aka a Firepower Detection Engine SSL Decryption Memory Consumption Denial of Service vulnerability. If this memory leak persists over time, a denial of service (DoS) condition could develop because traffic can cease to be forwarded through the device. The vulnerability is due to an error in how the Firepower Detection Snort Engine handles SSL traffic decryption and notifications to and from the Adaptive Security Appliance (ASA) handler. An attacker could exploit this vulnerability by sending a steady stream of malicious Secure Sockets Layer (SSL) traffic through the device. An exploit could allow the attacker to cause a DoS condition when the device runs low on system memory. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.0.1 and later, running on any of the following Cisco products: Adaptive Security Appliance (ASA) 5500-X Series Next-Generation Firewalls, Firepower 2100 Series Security Appliances, Firepower 4100 Series Security Appliances, Firepower 9300 Series Security Appliances. Cisco Bug IDs: CSCve02069. |
| A flaw in the AIX 5.3, 6.1, 7.1, and 7.2 JRE/SDK installp and updatep packages prevented the java.security, java.policy and javaws.policy files from being updated correctly. IBM X-Force ID: 130809. |
| Bolt before 3.3.6 does not properly restrict access to _profiler routes, related to EventListener/ProfilerListener.php and Provider/EventListenerServiceProvider.php. |
| A vulnerability in the Traversal Using Relay NAT (TURN) server included with Cisco Meeting Server (CMS) could allow an authenticated, remote attacker to gain unauthenticated or unauthorized access to components of or sensitive information in an affected system. The vulnerability is due to an incorrect default configuration of the TURN server, which could expose internal interfaces and ports on the external interface of an affected system. An attacker could exploit this vulnerability by using a TURN server to perform an unauthorized connection to a Call Bridge, a Web Bridge, or a database cluster in an affected system, depending on the deployment model and CMS services in use. A successful exploit could allow the attacker to gain unauthenticated access to a Call Bridge or database cluster in an affected system or gain unauthorized access to sensitive meeting information in an affected system. To exploit this vulnerability, the attacker must have valid credentials for the TURN server of the affected system. This vulnerability affects Cisco Meeting Server (CMS) deployments that are running a CMS Software release prior to Release 2.0.16, 2.1.11, or 2.2.6. Cisco Bug IDs: CSCvf51127. |
| A vulnerability in the Cisco FindIT Network Discovery Utility could allow an authenticated, local attacker to perform a DLL preloading attack, potentially causing a partial impact to device availability, confidentiality, and integrity. The vulnerability is due to the application loading a malicious copy of a specific, nondefined DLL file instead of the DLL file it was expecting. An attacker could exploit this vulnerability by placing an affected DLL within the search path of the host system. An exploit could allow the attacker to load a malicious DLL file into the system, thus partially compromising confidentiality, integrity, and availability on the device. Cisco Bug IDs: CSCve89785. |
| A vulnerability in the Akamai Connect feature of Cisco Wide Area Application Services (WAAS) Appliances could allow an unauthenticated, remote attacker to cause a denial-of-service (DoS) condition on an affected device. The vulnerability is due to certain file-handling inefficiencies of the affected system. An attacker could exploit this vulnerability by directing client systems to access a corrupted file that the client systems cannot decompress correctly. A successful exploit could allow the attacker to cause the affected device to crash or hang unexpectedly and result in a DoS condition that may require manual intervention to regain normal operating conditions. Cisco Bug IDs: CSCve82472. |
| A vulnerability in the web framework of Cisco WebEx Meetings Server could allow an unauthenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a user of the web interface of an affected system. The vulnerability is due to insufficient input validation of some parameters that are passed to the web server of the affected system. An attacker could exploit this vulnerability by convincing a user to follow a malicious link or by intercepting a user request and injecting malicious code into the request. A successful exploit could allow the attacker to execute arbitrary script code in the context of the affected web interface or allow the attacker to access sensitive browser-based information. Cisco Bug IDs: CSCve96608. |
| A vulnerability in the implementation of Session Initiation Protocol (SIP) functionality in Cisco Small Business SPA50x, SPA51x, and SPA52x Series IP Phones could allow an unauthenticated, remote attacker to cause an affected device to become unresponsive, resulting in a denial of service (DoS) condition. The vulnerability is due to the improper handling of SIP request messages by an affected device. An attacker could exploit this vulnerability by using formatted specifiers in a SIP payload that is sent to an affected device. A successful exploit could allow the attacker to cause the affected device to become unresponsive, resulting in a DoS condition that persists until the device is restarted manually. This vulnerability affects Cisco Small Business SPA50x, SPA51x, and SPA52x Series IP Phones that are running firmware release 7.6.2SR1 or earlier. Cisco Bug IDs: CSCvc63986. |
| A vulnerability within the firewall configuration of the Cisco Application Policy Infrastructure Controller Enterprise Module (APIC-EM) could allow an unauthenticated, adjacent attacker to gain privileged access to services only available on the internal network of the device. The vulnerability is due to an incorrect firewall rule on the device. The misconfiguration could allow traffic sent to the public interface of the device to be forwarded to the internal virtual network of the APIC-EM. An attacker that is logically adjacent to the network on which the public interface of the affected APIC-EM resides could leverage this behavior to gain access to services listening on the internal network with elevated privileges. This vulnerability affects appliances or virtual devices running Cisco Application Policy Infrastructure Controller Enterprise Module prior to version 1.5. Cisco Bug IDs: CSCve89638. |
