| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the web-based management interface of Cisco Small Business 100, 300, and 500 Series Wireless APs could allow an authenticated, remote attacker to perform command injection attacks against an affected device. In order to exploit this vulnerability, the attacker must have valid administrative credentials for the device. This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by sending a crafted HTTP request to the web-based management interface of an affected device. A successful exploit could allow the attacker to execute arbitrary code as the root user on the underlying operating system. |
| A vulnerability in the Network Configuration Access Control Module (NACM) of Cisco IOS XE Software could allow an authenticated, remote attacker to obtain unauthorized read access to configuration or operational data.
This vulnerability exists because a subtle change in inner API call behavior causes results to be filtered incorrectly. An attacker could exploit this vulnerability by using either NETCONF, RESTCONF, or gRPC Network Management Interface (gNMI) protocols and query data on paths that may have been denied by the NACM configuration. A successful exploit could allow the attacker to access data that should have been restricted according to the NACM configuration.
Note: This vulnerability requires that the attacker obtain the credentials from a valid user with privileges lower than 15, and that NACM was configured to provide restricted read access for that user. |
| A vulnerability in the Cisco Express Forwarding functionality of Cisco IOS XE Software for Cisco ASR 903 Aggregation Services Routers with Route Switch Processor 3 (RSP3C) could allow an unauthenticated, adjacent attacker to trigger a denial of service (DoS) condition.
This vulnerability is due to improper memory management when Cisco IOS XE Software is processing Address Resolution Protocol (ARP) messages. An attacker could exploit this vulnerability by sending crafted ARP messages at a high rate over a period of time to an affected device. A successful exploit could allow the attacker to exhaust system resources, which eventually triggers a reload of the active route switch processor (RSP). If a redundant RSP is not present, the router reloads. |
| hawtio before version 1.5.5 is vulnerable to remote code execution via file upload. An attacker could use this vulnerability to upload a crafted file which could be executed on a target machine where hawtio is deployed. |
| A security issue was found in Sparkle before version 2.6.4. An attacker can replace an existing signed update with another payload, bypassing Sparkle’s (Ed)DSA signing checks. |
| A vulnerability in the implementation of the Simple Network Management Protocol Version 3 (SNMPv3) feature of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to poll an affected device using SNMP, even if the device is configured to deny SNMP traffic from an unauthorized source or the SNMPv3 username is removed from the configuration.
This vulnerability exists because of the way that the SNMPv3 configuration is stored in the Cisco IOS Software and Cisco IOS XE Software startup configuration. An attacker could exploit this vulnerability by polling an affected device from a source address that should have been denied. A successful exploit could allow the attacker to perform SNMP operations from a source that should be denied.
Note: The attacker has no control of the SNMPv3 configuration. To exploit this vulnerability, the attacker must have valid SNMPv3 user credentials.
For more information, see the section of this advisory. |
| Tuleap is an Open Source Suite created to facilitate management of software development and collaboration. In Tuleap Community Edition prior to version 16.9.99.1751892857 and Tuleap Enterprise Edition prior to 16.8-5 and 16.9-3, malicious users with some control over certain artifacts could insert malicious code when displaying the children of a parent artifact to force victims to execute the uncontrolled code. This is fixed in version Tuleap Community Edition prior to version 16.9.99.1751892857 and Tuleap Enterprise Edition prior to 16.8-5 and 16.9-3. |
| A vulnerability in the access control list (ACL) programming of Cisco IOS Software that is running on Cisco Catalyst 1000 Switches and Cisco Catalyst 2960L Switches could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability is due to the use of both an IPv4 ACL and a dynamic ACL of IP Source Guard on the same interface, which is an unsupported configuration. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to bypass an ACL on the affected device.
Note: Cisco documentation has been updated to reflect that this is an unsupported configuration. However, Cisco is publishing this advisory because the device will not prevent an administrator from configuring both features on the same interface. There are no plans to implement the ability to configure both features on the same interface on Cisco Catalyst 1000 or Catalyst 2960L Switches. |
| A vulnerability in the Cisco Discovery Protocol implementation for Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to cause the Cisco Discovery Protocol process to reload on an affected device.
This vulnerability is due to a heap buffer overflow in certain Cisco Discovery Protocol messages. An attacker could exploit this vulnerability by sending a malicious Cisco Discovery Protocol packet to an affected device. A successful exploit could allow the attacker to cause a heap overflow, which could cause the Cisco Discovery Protocol process to reload on the device. The bytes that can be written in the buffer overflow are restricted, which limits remote code execution.Note: Cisco Discovery Protocol is a Layer 2 protocol. To exploit this vulnerability, an attacker must be in the same broadcast domain as the affected device (Layer 2 adjacent). Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability.This advisory is part of the September 2022 release of the Cisco IOS XR Software Security Advisory Bundled Publication. For a complete list of the advisories and links to them, see . |
| Cross-site scripting in certain Zoom Clients before version 6.4.5 may allow an authenticated user to conduct a disclosure of information via network access. |
| Insufficient control flow management in certain Zoom Clients for iOS before version 6.4.5 may allow an unauthenticated user to conduct a disclosure of information via network access. |
| Classic buffer overflow in certain Zoom Clients for Windows may allow an authorised user to conduct a denial of service via network access. |
| NULL pointer dereference in some Zoom Workplace Apps for Windows may allow an authenticated user to conduct a denial of service via network access. |
| Improper input validation in the installer for Zoom Workplace Desktop App for Windows before version 6.0.10 may allow an authenticated user to conduct a denial of service via local access. |
| NULL pointer dereference in some Zoom Workplace Apps for Windows may allow an authenticated user to conduct a denial of service via network access. |
| Improper certificate validation in Zoom Workplace for Linux before version 6.4.13 may allow an unauthorized user to conduct an information disclosure via network access. |
| Race condition in the installer for some Zoom Apps and SDKs for Windows before version 6.0.0 may allow an authenticated user to conduct a privilege escalation via local access. |
| Improper input validation in the installer for some Zoom Apps for Windows may allow an authenticated user to conduct a privilege escalation via local access. |
| Uncontrolled search path element in the installer for Zoom Workplace Desktop App for macOS before version 6.0.10 may allow an authenticated user to conduct a denial of service via local access. |
| Race condition in the installer for Zoom Workplace App for Windows and Zoom Rooms App for Windows may allow an authenticated user to conduct a denial of service via local access. |
