| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the software-based SSL/TLS message handler of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability is due to insufficient validation of SSL/TLS messages when the device performs software-based SSL/TLS decryption. An attacker could exploit this vulnerability by sending a crafted SSL/TLS message to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. Note: Datagram TLS (DTLS) messages cannot be used to exploit this vulnerability. |
| A vulnerability in the Simple Network Management Protocol version 3 (SNMPv3) access control functionality of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to query SNMP data. This vulnerability is due to ineffective access control. An attacker could exploit this vulnerability by sending an SNMPv3 query to an affected device from a host that is not permitted by the SNMPv3 access control list. A successful exploit could allow the attacker to send an SNMP query to an affected device and retrieve information from the device. The attacker would need valid credentials to perform the SNMP query. |
| Multiple Cisco products are affected by a vulnerability in Snort rules that could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.The vulnerability is due to improper handling of the Block with Reset or Interactive Block with Reset actions if a rule is configured without proper constraints. An attacker could exploit this vulnerability by sending a crafted IP packet to the affected device. A successful exploit could allow the attacker to cause through traffic to be dropped. Note: Only products with Snort3 configured and either a rule with Block with Reset or Interactive Block with Reset actions configured are vulnerable. Products configured with Snort2 are not vulnerable. |
| A vulnerability in the logging subsystem of the Cisco Firepower Threat Defense (FTD) Firepower Device Manager (FDM) could allow an unauthenticated, remote attacker to add arbitrary entries to the audit log. This vulnerability affects Cisco Firepower Threat Defense Software versions 6.1.x on the following vulnerable products that have enabled FDM: ASA5506-X ASA5506W-X ASA5506H-X ASA5508-X ASA5516-X ASA5512-X ASA5515-X ASA5525-X ASA5545-X ASA5555-X. More Information: CSCvb86860. Known Affected Releases: FRANGELICO. Known Fixed Releases: 6.2.0. |
| A vulnerability in the detection engine that handles Secure Sockets Layer (SSL) packets for Cisco Firepower System Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition because the Snort process unexpectedly restarts. This vulnerability affects Cisco Firepower System Software prior to the first fixed release when it is configured with an SSL Decrypt-Resign policy. More Information: CSCvb62292. Known Affected Releases: 6.0.1 6.1.0 6.2.0. Known Fixed Releases: 6.2.0 6.1.0.2. |
| A vulnerability in the detection engine of Cisco Firepower Threat Defense software could allow an unauthenticated, remote attacker to bypass a configured Secure Sockets Layer (SSL) Access Control (AC) policy to block SSL traffic. The vulnerability is due to the incorrect handling of TCP SSL packets received out of order. An attacker could exploit this vulnerability by sending a crafted SSL connection through the affected device. A successful exploit could allow the attacker to bypass a configured SSL AC policy to block SSL traffic. Cisco Bug IDs: CSCvg09316. |
| A vulnerability in the logging configuration of Secure Sockets Layer (SSL) policies for Cisco FirePOWER System Software 5.3.0 through 6.2.2 could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition due to high consumption of system resources. The vulnerability is due to the logging of certain TCP packets by the affected software. An attacker could exploit this vulnerability by sending a flood of crafted TCP packets to an affected device. A successful exploit could allow the attacker to cause a DoS condition. The success of an exploit is dependent on how an administrator has configured logging for SSL policies for a device. This vulnerability affects Cisco FirePOWER System Software that is configured to log connections by using SSL policy default actions. Cisco Bug IDs: CSCvd07072. |
| A vulnerability in the Secure Sockets Layer (SSL) VPN functionality of the Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to cause a reload of the affected system or to remotely execute code. The vulnerability is due to an attempt to double free a region of memory when the webvpn feature is enabled on the Cisco ASA device. An attacker could exploit this vulnerability by sending multiple, crafted XML packets to a webvpn-configured interface on the affected system. An exploit could allow the attacker to execute arbitrary code and obtain full control of the system, or cause a reload of the affected device. This vulnerability affects Cisco ASA Software that is running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, ASA 1000V Cloud Firewall, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4110 Security Appliance, Firepower 9300 ASA Security Module, Firepower Threat Defense Software (FTD). Cisco Bug IDs: CSCvg35618. |
| A vulnerability in the processing of SSH connections of Cisco Firepower Management Center (FMC) and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper error handling when an SSH session fails to be established. An attacker could exploit this vulnerability by sending a high rate of crafted SSH connections to the instance. A successful exploit could allow the attacker to cause resource exhaustion, resulting in a reboot on the affected device. |
| Multiple vulnerabilities in the Server Message Block Version 2 (SMB2) processor of the Snort detection engine on multiple Cisco products could allow an unauthenticated, remote attacker to bypass the configured policies or cause a denial of service (DoS) condition on an affected device.
These vulnerabilities are due to improper management of system resources when the Snort detection engine is processing SMB2 traffic. An attacker could exploit these vulnerabilities by sending a high rate of certain types of SMB2 packets through an affected device. A successful exploit could allow the attacker to trigger a reload of the Snort process, resulting in a DoS condition.
Note: When the snort preserve-connection option is enabled for the Snort detection engine, a successful exploit could also allow the attacker to bypass the configured policies and deliver a malicious payload to the protected network. The snort preserve-connection setting is enabled by default. See the Details ["#details"] section of this advisory for more information.
Note: Only products that have Snort 3 configured are affected. Products that are configured with Snort 2 are not affected. |
| A vulnerability in the CLI of Cisco Firepower Threat Defense (FTD) Software and Cisco FXOS Software could allow an authenticated, local attacker to execute arbitrary commands on the underlying operating system as root.
This vulnerability is due to improper input validation for specific CLI commands. An attacker could exploit this vulnerability by injecting operating system commands into a legitimate command. A successful exploit could allow the attacker to escape the restricted command prompt and execute arbitrary commands on the underlying operating system. To successfully exploit this vulnerability, an attacker would need valid Administrator credentials. |
| A vulnerability in the TLS handler of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to gain access to sensitive information.
This vulnerability is due to improper implementation of countermeasures against a Bleichenbacher attack on a device that uses SSL decryption policies. An attacker could exploit this vulnerability by sending crafted TLS messages to an affected device, which would act as an oracle and allow the attacker to carry out a chosen-ciphertext attack. A successful exploit could allow the attacker to perform cryptanalytic operations that may allow decryption of previously captured TLS sessions to the affected device. |
| Multiple vulnerabilities in the Server Message Block Version 2 (SMB2) processor of the Snort detection engine on multiple Cisco products could allow an unauthenticated, remote attacker to bypass the configured policies or cause a denial of service (DoS) condition on an affected device.
These vulnerabilities are due to improper management of system resources when the Snort detection engine is processing SMB2 traffic. An attacker could exploit these vulnerabilities by sending a high rate of certain types of SMB2 packets through an affected device. A successful exploit could allow the attacker to trigger a reload of the Snort process, resulting in a DoS condition.
Note: When the snort preserve-connection option is enabled for the Snort detection engine, a successful exploit could also allow the attacker to bypass the configured policies and deliver a malicious payload to the protected network. The snort preserve-connection setting is enabled by default. See the Details ["#details"] section of this advisory for more information.
Note: Only products that have Snort 3 configured are affected. Products that are configured with Snort 2 are not affected. |
| A vulnerability in the generic routing encapsulation (GRE) tunnel decapsulation feature of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to a memory handling error that occurs when GRE traffic is processed. An attacker could exploit this vulnerability by sending a crafted GRE payload through an affected device. A successful exploit could allow the attacker to cause the device to restart, resulting in a DoS condition.
https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-ftd-gre-dos-hmedHQPM ["https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-ftd-gre-dos-hmedHQPM"]
This advisory is part of the November 2022 release of the Cisco ASA, FTD, and FMC Security Advisory Bundled publication. |
| A vulnerability in the management web server of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker with high privileges to execute configuration commands on an affected system.
This vulnerability exists because access to HTTPS endpoints is not properly restricted on an affected device. An attacker could exploit this vulnerability by sending specific messages to the affected HTTPS handler. A successful exploit could allow the attacker to perform configuration changes on the affected system, which should be configured and managed only through Cisco Firepower Management Center (FMC) Software. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| A vulnerability in the Sourcefire tunnel control channel protocol in Cisco Firepower System Software running on Cisco Firepower Threat Defense (FTD) sensors could allow an authenticated, local attacker to execute specific CLI commands with root privileges on the Cisco Firepower Management Center (FMC), or through Cisco FMC on other Firepower sensors and devices that are controlled by the same Cisco FMC. To send the commands, the attacker must have root privileges for at least one affected sensor or the Cisco FMC. The vulnerability exists because the affected software performs insufficient checks for certain CLI commands, if the commands are executed via a Sourcefire tunnel connection. An attacker could exploit this vulnerability by authenticating with root privileges to a Firepower sensor or Cisco FMC, and then sending specific CLI commands to the Cisco FMC or through the Cisco FMC to another Firepower sensor via the Sourcefire tunnel connection. A successful exploit could allow the attacker to modify device configurations or delete files on the device that is running Cisco FMC Software or on any Firepower device that is managed by Cisco FMC. |
| A vulnerability in the local malware analysis process of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on the affected device. This vulnerability is due to insufficient error handling in the local malware analysis process of an affected device. An attacker could exploit this vulnerability by sending a crafted file through the device. A successful exploit could allow the attacker to cause the local malware analysis process to crash, which could result in a DoS condition. Notes: Manual intervention may be required to recover from this situation. Malware cloud lookup and dynamic analysis will not be impacted. |
| A vulnerability in the Simple Network Management Protocol (SNMP) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by sending a crafted SNMP request to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| A vulnerability in dynamic access policies (DAP) functionality of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition.
This vulnerability is due to improper processing of HostScan data received from the Posture (HostScan) module. An attacker could exploit this vulnerability by sending crafted HostScan data to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition.
https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-asa-ftd-dap-dos-GhYZBxDU ["https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-asa-ftd-dap-dos-GhYZBxDU"]
This advisory is part of the November 2022 release of the Cisco ASA, FTD, and FMC Security Advisory Bundled publication. |
