| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
of: overlay: fix null pointer dereferencing in find_dup_cset_node_entry() and find_dup_cset_prop()
When kmalloc() fail to allocate memory in kasprintf(), fn_1 or fn_2 will
be NULL, and strcmp() will cause null pointer dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
cifs: Fix the error length of VALIDATE_NEGOTIATE_INFO message
Commit d5c7076b772a ("smb3: add smb3.1.1 to default dialect list")
extend the dialects from 3 to 4, but forget to decrease the extended
length when specific the dialect, then the message length is larger
than expected.
This maybe leak some info through network because not initialize the
message body.
After apply this patch, the VALIDATE_NEGOTIATE_INFO message length is
reduced from 28 bytes to 26 bytes. |
| In the Linux kernel, the following vulnerability has been resolved:
net: broadcom: bcm4908_enet: update TX stats after actual transmission
Queueing packets doesn't guarantee their transmission. Update TX stats
after hardware confirms consuming submitted data.
This also fixes a possible race and NULL dereference.
bcm4908_enet_start_xmit() could try to access skb after freeing it in
the bcm4908_enet_poll_tx(). |
| In the Linux kernel, the following vulnerability has been resolved:
gpu: lontium-lt9611: Fix NULL pointer dereference in lt9611_connector_init()
A NULL check for bridge->encoder shows that it may be NULL, but it
already been dereferenced on all paths leading to the check.
812 if (!bridge->encoder) {
Dereference the pointer bridge->encoder.
810 drm_connector_attach_encoder(<9611->connector, bridge->encoder); |
| In the Linux kernel, the following vulnerability has been resolved:
objtool: Fix SEGFAULT
find_insn() will return NULL in case of failure. Check insn in order
to avoid a kernel Oops for NULL pointer dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: Fix use-after-free in ath9k_hif_usb_disconnect()
This patch fixes a use-after-free in ath9k that occurs in
ath9k_hif_usb_disconnect() when ath9k_destroy_wmi() is trying to access
'drv_priv' that has already been freed by ieee80211_free_hw(), called by
ath9k_htc_hw_deinit(). The patch moves ath9k_destroy_wmi() before
ieee80211_free_hw(). Note that urbs from the driver should be killed
before freeing 'wmi' with ath9k_destroy_wmi() as their callbacks will
access 'wmi'.
Found by a modified version of syzkaller.
==================================================================
BUG: KASAN: use-after-free in ath9k_destroy_wmi+0x38/0x40
Read of size 8 at addr ffff8881069132a0 by task kworker/0:1/7
CPU: 0 PID: 7 Comm: kworker/0:1 Tainted: G O 5.14.0+ #131
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS rel-1.12.1-0-ga5cab58e9a3f-prebuilt.qemu.org 04/01/2014
Workqueue: usb_hub_wq hub_event
Call Trace:
dump_stack_lvl+0x8e/0xd1
print_address_description.constprop.0.cold+0x93/0x334
? ath9k_destroy_wmi+0x38/0x40
? ath9k_destroy_wmi+0x38/0x40
kasan_report.cold+0x83/0xdf
? ath9k_destroy_wmi+0x38/0x40
ath9k_destroy_wmi+0x38/0x40
ath9k_hif_usb_disconnect+0x329/0x3f0
? ath9k_hif_usb_suspend+0x120/0x120
? usb_disable_interface+0xfc/0x180
usb_unbind_interface+0x19b/0x7e0
? usb_autoresume_device+0x50/0x50
device_release_driver_internal+0x44d/0x520
bus_remove_device+0x2e5/0x5a0
device_del+0x5b2/0xe30
? __device_link_del+0x370/0x370
? usb_remove_ep_devs+0x43/0x80
? remove_intf_ep_devs+0x112/0x1a0
usb_disable_device+0x1e3/0x5a0
usb_disconnect+0x267/0x870
hub_event+0x168d/0x3950
? rcu_read_lock_sched_held+0xa1/0xd0
? hub_port_debounce+0x2e0/0x2e0
? check_irq_usage+0x860/0xf20
? drain_workqueue+0x281/0x360
? lock_release+0x640/0x640
? rcu_read_lock_sched_held+0xa1/0xd0
? rcu_read_lock_bh_held+0xb0/0xb0
? lockdep_hardirqs_on_prepare+0x273/0x3e0
process_one_work+0x92b/0x1460
? pwq_dec_nr_in_flight+0x330/0x330
? rwlock_bug.part.0+0x90/0x90
worker_thread+0x95/0xe00
? __kthread_parkme+0x115/0x1e0
? process_one_work+0x1460/0x1460
kthread+0x3a1/0x480
? set_kthread_struct+0x120/0x120
ret_from_fork+0x1f/0x30
The buggy address belongs to the page:
page:ffffea00041a44c0 refcount:0 mapcount:0 mapping:0000000000000000 index:0x0 pfn:0x106913
flags: 0x200000000000000(node=0|zone=2)
raw: 0200000000000000 0000000000000000 dead000000000122 0000000000000000
raw: 0000000000000000 0000000000000000 00000000ffffffff 0000000000000000
page dumped because: kasan: bad access detected
page_owner tracks the page as freed
page last allocated via order 3, migratetype Unmovable, gfp_mask 0x40dc0(GFP_KERNEL|__GFP_COMP|__GFP_ZERO), pid 7, ts 38347963444, free_ts 41399957635
prep_new_page+0x1aa/0x240
get_page_from_freelist+0x159a/0x27c0
__alloc_pages+0x2da/0x6a0
alloc_pages+0xec/0x1e0
kmalloc_order+0x39/0xf0
kmalloc_order_trace+0x19/0x120
__kmalloc+0x308/0x390
wiphy_new_nm+0x6f5/0x1dd0
ieee80211_alloc_hw_nm+0x36d/0x2230
ath9k_htc_probe_device+0x9d/0x1e10
ath9k_htc_hw_init+0x34/0x50
ath9k_hif_usb_firmware_cb+0x25f/0x4e0
request_firmware_work_func+0x131/0x240
process_one_work+0x92b/0x1460
worker_thread+0x95/0xe00
kthread+0x3a1/0x480
page last free stack trace:
free_pcp_prepare+0x3d3/0x7f0
free_unref_page+0x1e/0x3d0
device_release+0xa4/0x240
kobject_put+0x186/0x4c0
put_device+0x20/0x30
ath9k_htc_disconnect_device+0x1cf/0x2c0
ath9k_htc_hw_deinit+0x26/0x30
ath9k_hif_usb_disconnect+0x2d9/0x3f0
usb_unbind_interface+0x19b/0x7e0
device_release_driver_internal+0x44d/0x520
bus_remove_device+0x2e5/0x5a0
device_del+0x5b2/0xe30
usb_disable_device+0x1e3/0x5a0
usb_disconnect+0x267/0x870
hub_event+0x168d/0x3950
process_one_work+0x92b/0x1460
Memory state around the buggy address:
ffff888106913180: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
ffff888106913200: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
>ffff888
---truncated--- |
| RFC inbound processing�does not perform necessary authorization checks for an authenticated user, resulting in escalation of privileges. On successful exploitation the attacker could critically impact both integrity and availability of the application. |
| In the Linux kernel, the following vulnerability has been resolved:
media: uvcvideo: Fix memory leak in uvc_gpio_parse
Previously the unit buffer was allocated before checking the IRQ for
privacy GPIO. In case of error, the unit buffer was leaked.
Allocate the unit buffer after the IRQ to avoid it.
Addresses-Coverity-ID: 1474639 ("Resource leak") |
| In Nessus versions prior to 10.8.4, a non-authenticated attacker could alter Nessus logging entries by manipulating http requests to the application. |
| In the Linux kernel, the following vulnerability has been resolved:
dm clone: Fix UAF in clone_dtr()
Dm_clone also has the same UAF problem when dm_resume()
and dm_destroy() are concurrent.
Therefore, cancelling timer again in clone_dtr(). |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in THEMECO Cornerstone cornerstone allows Stored XSS.This issue affects Cornerstone: from n/a through <= 7.7.3. |
| Exposure of Sensitive System Information to an Unauthorized Control Sphere vulnerability in Shahjada Download Manager download-manager allows Retrieve Embedded Sensitive Data.This issue affects Download Manager: from n/a through <= 3.3.32. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: snic: Fix possible UAF in snic_tgt_create()
Smatch reports a warning as follows:
drivers/scsi/snic/snic_disc.c:307 snic_tgt_create() warn:
'&tgt->list' not removed from list
If device_add() fails in snic_tgt_create(), tgt will be freed, but
tgt->list will not be removed from snic->disc.tgt_list, then list traversal
may cause UAF.
Remove from snic->disc.tgt_list before free(). |
| In the Linux kernel, the following vulnerability has been resolved:
jbd2: fix potential buffer head reference count leak
As in 'jbd2_fc_wait_bufs' if buffer isn't uptodate, will return -EIO without
update 'journal->j_fc_off'. But 'jbd2_fc_release_bufs' will release buffer head
from ‘j_fc_off - 1’ if 'bh' is NULL will terminal release which will lead to
buffer head buffer head reference count leak.
To solve above issue, update 'journal->j_fc_off' before return -EIO. |
| Authenticated command injection vulnerability in the command line interface of a network management service. Successful exploitation of this vulnerability could allow an attacker to execute arbitrary commands as a privileged user on the underlying operating system. |
| Exposure of Sensitive System Information to an Unauthorized Control Sphere vulnerability in sizam REHub Framework rehub-framework allows Retrieve Embedded Sensitive Data.This issue affects REHub Framework: from n/a through < 19.9.9.4. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: tag_8021q: avoid leaking ctx on dsa_tag_8021q_register() error path
If dsa_tag_8021q_setup() fails, for example due to the inability of the
device to install a VLAN, the tag_8021q context of the switch will leak.
Make sure it is freed on the error path. |
| In the Linux kernel, the following vulnerability has been resolved:
remoteproc: sysmon: fix memory leak in qcom_add_sysmon_subdev()
The kfree() should be called when of_irq_get_byname() fails or
devm_request_threaded_irq() fails in qcom_add_sysmon_subdev(),
otherwise there will be a memory leak, so add kfree() to fix it. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in Xpro Xpro Elementor Addons xpro-elementor-addons allows DOM-Based XSS.This issue affects Xpro Elementor Addons: from n/a through <= 1.4.19.1. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix potential memory leak in wilc_mac_xmit()
The wilc_mac_xmit() returns NETDEV_TX_OK without freeing skb, add
dev_kfree_skb() to fix it. Compile tested only. |
