| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| vllm before 0.29.0 fails to enforce VLLM_MAX_AUDIO_CLIP_FILESIZE_MB limit in multimodal chat audio decoding, allowing unauthenticated clients to bypass file size restrictions. Attackers can submit oversized audio files through chat endpoints to consume excessive memory and CPU resources during decoding. |
| A flaw has been found in Trusted Domain Project OpenDMARC up to 1.4.2. Affected by this vulnerability is the function opendmarc_spf_ipv6_explode in the library libopendmarc/opendmarc_spf.c of the component SPF Parser. This manipulation of the argument cp causes null pointer dereference. It is possible to initiate the attack remotely. The exploit has been published and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability in the DHCP snooping feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause BOOTP packets to be forwarded between VLANs, resulting in a denial of service (DoS) condition.
This vulnerability is due to improper handling of BOOTP packets on Cisco Catalyst 9000 Series Switches. An attacker could exploit this vulnerability by sending BOOTP request packets to an affected device. A successful exploit could allow an attacker to forward BOOTP packets from one VLAN to another, resulting in BOOTP VLAN leakage and potentially leading to high CPU utilization. This makes the device unreachable (either through console or remote management) and unable to forward traffic, resulting in a DoS condition.
Note: This vulnerability can be exploited with either unicast or broadcast BOOTP packets.
There are workarounds that address this vulnerability. |
| containerd is an open-source container runtime. Prior to versions 1.7.36, 2.0.13, 2.2.9, 2.3.6, and 2.4.1, a crafted OCI index graph can force very high CPU/memory usage during PullImage (before container start), causing long ContainerCreating stalls and, at larger sizes, node/runtime instability. Versions 1.7.36, 2.0.13, 2.2.9, 2.3.6, and 2.4.1 fix the issue. |
| nodemailer before 10.0.6 contains a denial of service vulnerability in the addressparser free-text fallback regex pattern that exhibits quadratic backtracking behavior. Attackers can supply crafted email header values with long whitespace-free runs to block the Node.js event loop for tens of seconds, causing service unavailability. |
| RabbitMQ is a messaging and streaming broker. From 3.13.0 until 3.13.15, 4.0.20, 4.1.11, and 4.2.6, mechanisms/1 applied list_to_atom/1 to every colon-delimited token in an attacker-controlled auth_mechanism value, permanently consuming Erlang VM atoms and allowing the node to be crashed with a large request. Exploitation requires the Shovel or Federation plugin to be in use, and setting auth_mechanism requires the policymaker tag. This issue is fixed in versions 3.13.15, 4.0.20, 4.1.11, and 4.2.6. |
| A vulnerability exists in the underlying operating system of HPE Networking EdgeConnect SD-WAN Gateways. Successful exploitation could allow an unauthenticated remote attacker to conduct a denial-of-service attack on the affected service. |
| Vulnerabilities in HPE Networking EdgeConnect SD-WAN Gateways could allow an unauthenticated remote attacker to cause a denial-of-service. Successful exploitation could allow an attacker to interrupt the normal operation of the affected service. |
| A vulnerability in the operating system of HPE Networking EdgeConnect SD-WAN Gateways could allow an authenticated local attacker to cause a denial-of-service. Successful exploitation could allow an attacker to disrupt system operations, potentially resulting in an unstable system state. |
| Vulnerabilities in HPE Networking EdgeConnect SD-WAN Gateways could allow an unauthenticated adjacent attacker to conduct denial-of-service attacks. Successful exploitation could allow an attacker to crash the system, preventing it from rebooting without manual intervention and disrupting network operations. |
| A vulnerability in HPE Networking EdgeConnect SD-WAN Gateways could allow an unauthenticated adjacent attacker to conduct a denial of service attack. Successful exploitation could allow an attacker to crash the system, preventing it from rebooting without manual intervention and disrupting network operations. |
| A vulnerability in HPE Networking EdgeConnect SD-WAN Gateways could allow an unauthenticated remote attacker to cause a denial-of-service against certain services running on impacted Gateways. |
| A security flaw has been discovered in Trusted Domain Project OpenARC up to 1.0.0.Beta1. Impacted is the function arc_parse_canon_t in the library libopenarc/arc-canon.c of the component libopenarc. The manipulation results in null pointer dereference. The attack may be launched remotely. The exploit has been released to the public and may be used for attacks. Upgrading to version 1.0.0.Beta0 is recommended to address this issue. Upgrading the affected component is advised. |
| A security flaw has been discovered in Ricoh SP 330DN, SP 221, SP C252SF and Aficio SP 3500SF up to 20260813. This affects an unknown part of the component HTTP Multipart Form-Data Parser. Performing a manipulation results in denial of service. The attack is possible to be carried out remotely. The exploit has been released to the public and may be used for attacks. The vendor was contacted early about this disclosure but did not respond in any way. |
| In the Linux kernel, the following vulnerability has been resolved:
i3c: master: svc: Prevent IRQ storm from false SLVSTART on NPCM845
On NPCM845, when a target on the I3C bus gets stuck holding SDA low,
the controller reports a false Master Request (MR) in-band interrupt
event. The driver handles this by emitting a STOP condition to restore
the bus.
However, the hardware quirk SVC_I3C_QUIRK_FALSE_SLVSTART indicates that
emitting a STOP condition may spuriously set the SLVSTART interrupt
status bit. In the Master Request case, this creates a feedback loop:
the STOP triggers a new SLVSTART event, the IRQ handler fires again,
the controller still reports an MR type, another STOP is emitted, and
the cycle repeats indefinitely, resulting in an IRQ storm that can lock
up the CPU.
Clear the SLVSTART status bit explicitly after emitting the STOP in the
Master Request IBI handler when the SVC_I3C_QUIRK_FALSE_SLVSTART quirk
is set. This breaks the feedback loop without affecting normal SLVSTART
processing, which is already guarded in the top-level IRQ handler by
checking that MSTATUS is in SLVREQ state. |
| In the Linux kernel, the following vulnerability has been resolved:
hpfs: handle set_blocksize failures
hpfs uses buffer_heads, which don't handle block size > PAGE_SIZE well.
Without this, mounting will hit the
BUG_ON(offset >= folio_size(folio));
in folio_set_bh on the first __bread_gfp call. |
| In the Linux kernel, the following vulnerability has been resolved:
serial: 8250: fix possible ISR soft lockup
There are rare cases in which the host gets stuck in the ISR because it
is flooded with messages during the startup phase.
The reason for the soft lockup in the ISR is the missing FIFO error IRQ
(FIFOE) handling. Not handling it and reporting IRQ_HANDLED triggers
the IRQ immediately again.
Fix this by adding a check for the FIFOE status and clearing the FIFO
if no data is ready (DR).
This behavior was observed on an AM62L device which uses the OMAP 8250
driver. Fix it for all 8250 drivers, since the OMAP driver's special
IRQ setup handling may trigger this behavior more frequently, but it
is not ensured that other 8250 drivers aren't affected. |
| In the Linux kernel, the following vulnerability has been resolved:
powercap: intel_rapl: Fix memory leak in rapl_add_package_cpuslocked()
When topology_physical_package_id()/topology_logical_die_id() returns
a negative value, rapl_add_package_cpuslocked() returns ERR_PTR(-EINVAL)
directly without freeing the rapl_package structure that was just
allocated by kzalloc_obj(), leaking memory on every failed package
addition.
Use the existing err_free_package label so that the allocation is
released on the error path. |
| OpenEXR is the reference implementation and specification for the EXR image format, widely used in the motion picture industry. Versions prior to 3.2.10, 3.3.12, and 3.4.13 contain an infinite-loop vulnerability in SampleCountChannel. The helper roundListSizeUp() rounds a sample-list size up to the next power of two using repeated unsigned left shifts, which terminates for normal values but fails for UINT_MAX: the sequence reaches 0x80000000, and the next left shift wraps the 32-bit value to 0. Because 0 remains less than UINT_MAX, the loop never progresses and never exits. The bug is reachable through public OpenEXRUtil APIs, either by editing the sample-count buffer through SampleCountChannel::Edit (whose destructor calls endEdit()) or by calling SampleCountChannel::set(x, y, UINT_MAX) on a valid pixel. This issue has been fixed in versions 3.2.10, 3.3.12, and 3.4.13. |
| The divi-dash WordPress plugin before 1.0.7 does not validate the source of the client IP address it uses for rate limiting and banning, allowing unauthenticated attackers to spoof arbitrary IP addresses in order to bypass rate limiting, ban chosen addresses from the feature, and grow a stored option without bound, resulting in denial of service. |
