| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: pci: Reject adapter interrupt forwarding if already enabled
The MPCIFC instruction doesn't allow registering adapter interrupts without
first unregistering. So reject any request to enable interrupt forwarding
if its already enabled for the zPCI device. This also fixes overwriting and
thus leaking resources when the ioctl is called multiple times for the same
device. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: use the subframe length when parsing A-MSDU TDLS frames
mwifiex_11n_dispatch_amsdu_pkt() splits an A-MSDU with
ieee80211_amsdu_to_8023s() and walks the resulting subframes. For each
subframe it passes the subframe data pointer to
mwifiex_process_tdls_action_frame(), but pairs it with skb->len, the
length of the A-MSDU parent, instead of rx_skb->len:
rx_skb = __skb_dequeue(&list);
rx_hdr = (struct rx_packet_hdr *)rx_skb->data;
if (ISSUPP_TDLS_ENABLED(priv->adapter->fw_cap_info) &&
ntohs(rx_hdr->eth803_hdr.h_proto) == ETH_P_TDLS) {
mwifiex_process_tdls_action_frame(priv, (u8 *)rx_hdr,
skb->len);
}
The parent is not a valid description of that buffer, and may not be
valid memory at all. ieee80211_amsdu_to_8023s() ends with
if (!reuse_skb)
dev_kfree_skb(skb);
and it only sets reuse_skb when the parent is linear, is not a
head_frag, and is being consumed as the *last* subframe. So when the
parent does not qualify for reuse it has already been freed, and the
read of skb->len is a use-after-free. When it is reused, skb->len is
the length of the last subframe, applied to every earlier subframe,
which over-states the buffer whenever an earlier subframe is shorter.
The callee cannot absorb a wrong length, because it derives its own
ceiling from the value it is given. Each frame type computes
ies_len = len - sizeof(struct ethhdr) - TDLS_*_FIX_LEN;
and the element walk is then bounded entirely against that ceiling,
for (end = pos + ies_len; pos + 1 < end; pos += 2 + pos[1]) {
u8 ie_len = pos[1];
if (pos + 2 + ie_len > end)
break;
so a too-large len moves end past the end of the subframe and the walk
reads and copies beyond it. The A-MSDU layout is chosen by the sender,
which makes the difference between the last subframe and a shorter
earlier one remotely selectable. Reaching this requires TDLS support in
firmware and the TDLS ethertype on the subframe.
The other caller, mwifiex_process_rx_packet(), is correct: it passes a
pointer and a length that describe the same region of the RX buffer.
Pass rx_skb->len, the length of the subframe actually being parsed. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/huge_memory: unlock i_mmap_rwsem before releasing after-split folios
__folio_split() keeps dereferencing the mapping after the split:
shmem_uncharge(mapping->host) and remap_page() while the folios are still
frozen/locked, and i_mmap_unlock_read(mapping) at the very end, after the
after-split folios have been unlocked and freed.
Nothing holds an inode reference across that. The split relies on @folio
-- which the beyond-EOF drop loop never removes, as it starts at
folio_next(folio) -- staying locked and in the page cache to hold off
eviction. But the unlock loop unlocks @folio before i_mmap_unlock_read()
runs. If the caller's @lock_at is a tail beyond EOF, as memory_failure()
passes when splitting a poisoned tail of a shmem THP that reaches past
i_size during truncation, it too is gone from the page cache; so once
@folio is unlocked no locked, in-cache folio pins the inode, and a
concurrent final iput() can evict and RCU-free it before
i_mmap_unlock_read() touches i_mmap_rwsem:
BUG: KASAN: slab-use-after-free in __up_read+0x634/0x790
i_mmap_unlock_read include/linux/fs.h:537 [inline]
__folio_split+0x732/0x1640 mm/huge_memory.c:4100
try_to_split_thp_page+0xab/0x390 mm/memory-failure.c:1675
memory_failure+0x1394/0x26e0 mm/memory-failure.c:2470
Freed by task 4601:
shmem_free_in_core_inode+0x54/0xb0 mm/shmem.c:5177
evict+0x57f/0xac0 fs/inode.c:870
Do every mapping dereference while @folio still pins the inode: drop
i_mmap_rwsem right after remap_page(), before the loop that unlocks and
frees the after-split folios, and clear @mapping so the exit path does not
unlock it again. shmem_uncharge() and remap_page() already run before
that point, so after this nothing past the unlock loop touches the inode
or the mapping.
This is now a rule the split depends on, alongside keeping @folio frozen
until the page cache is updated: no inode or mapping dereference once the
after-split folios start being unlocked. |
| In the Linux kernel, the following vulnerability has been resolved:
um: vector: fix use-after-free in vector_mmsg_rx()
When vector_mmsg_rx() discards a packet whose overlay header fails
verify_header(), it frees the skb and continues the loop:
if (header_check < 0) {
dev_kfree_skb_irq(skb);
vp->estats.rx_encaps_errors++;
continue;
}
The normal and short-packet paths fall through to the bottom of the
loop body, which clears the consumed slot and advances the cursors:
(*skbuff_vector) = NULL;
mmsg_vector++;
skbuff_vector++;
The verify_header() < 0 path skips that via continue, so the freed skb
is left in skbuff_vector[] and the cursors do not advance. The next
iteration reads the same slot, gets the freed skb, and frees it again,
producing a refcount underflow / use-after-free in the RX path.
Discard the slot the same way the other paths do before continuing.
Only transports whose verify_header() can return negative are affected:
GRE and L2TPv3 do so on a cookie/session-id mismatch (raw/tap do not),
so any peer on such a transport can trigger it without authentication. |
| In the Linux kernel, the following vulnerability has been resolved:
ublk: reset kernel-owned dev_info fields in ublk_ctrl_add_dev()
ublk_ctrl_add_dev() memcpy()s the userspace ublksrv_ctrl_dev_info into
ub->dev_info and then fixes up the fields the driver owns, but misses
->state and ->ublksrv_pid.
A device added with ->state = UBLK_S_DEV_LIVE passes the
"->state != UBLK_S_DEV_DEAD" test that ublk_stop_dev_unlocked() uses as its
proxy for "a disk is attached", while ->ub_disk is still NULL, so DEL_DEV
right after ADD_DEV oopses in del_gendisk(). UBLK_S_DEV_QUIESCED plus
UBLK_F_USER_RECOVERY dies one step earlier, in ublk_force_abort_dev(). A
poisoned ->state also gets START_USER_RECOVERY and the char device
read/write path onto a device that was never started, and wedges START_DEV
at -EEXIST. A poisoned ->ublksrv_pid just makes GET_DEV_INFO report an
unrelated task as the ublk server.
Reset both after the memcpy(), as ublk_detach_disk() does. Userspace only
ever reads these back, so correcting them silently breaks nothing.
ADD_DEV has copied ->state in unsanitized since ublk was merged, but back
then it was harmless: the gendisk was allocated during ADD_DEV, and both
teardown and the START_DEV -EEXIST check keyed off disk_live() rather than
->state. The oops became reachable once the disk allocation moved to
START_DEV and those checks switched to ->state. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: fib6: fix NULL deref in fib6_walk_continue() on multi-batch dump
inet6_dump_fib() saves its progress in cb->args[1] as a positional
index within the current hash chain. Between batches, a concurrent
fib6_new_table() can insert a new table at the chain head, shifting
all existing entries. The saved index then lands on a different
table, causing fib6_dump_table() to set w->root to the wrong table
while w->node still points into the previous one.
fib6_walk_continue() dereferences w->node->parent (NULL) and panics:
BUG: kernel NULL pointer dereference, address: 0000000000000008
RIP: 0010:fib6_walk_continue+0x6e/0x170
Call Trace:
<TASK>
fib6_dump_table.isra.0+0xc5/0x240
inet6_dump_fib+0xf6/0x420
rtnl_dumpit+0x30/0xa0
netlink_dump+0x15b/0x460
netlink_recvmsg+0x1d6/0x2a0
____sys_recvmsg+0x17a/0x190
Fix by storing tb->tb6_id in cb->args[1] instead of a positional
index. On resume, skip entries until the id matches; a concurrent
head-insert can never match the saved id, so the walker always
resumes on the correct table. |
| No cwe for this issue in Visual Studio Code CoPilot Chat Extension allows an unauthorized attacker to bypass a security feature over a network. |
| 4gaBoards is a boards system for realtime project management. Prior to 3.3.9, 4gaBoards allows an authenticated user to modify ssoGoogleId, ssoGoogleEmail, ssoGithubId, ssoGithubUsername, ssoGithubEmail, ssoMicrosoftId, ssoMicrosoftEmail, ssoOidcId, and ssoOidcEmail through PATCH /api/users/:id. The whitelist in server/api/controllers/users/update.js mass assigns these backend-managed identity attributes from user input. An attacker can place a victim's provider identifier on an attacker-controlled account, causing the default lookup in helpers such as server/api/helpers/users/get-create-one-for-github-sso.js to match the victim's first SSO login to the attacker's account before the email-linkage flow runs. The victim is logged into the attacker-controlled account, and projects, boards, or data the victim creates remain accessible through the attacker's original local credentials. This issue is fixed in version 3.3.9. |
| Streambert is a cross-platform Electron Desktop App to stream and download video content. Prior to 2.5.0, the downloadSubtitleFile utility in src/ipc/downloads.js, reached through the run-download IPC channel, accepts a renderer-supplied subtitle url using the file: URI scheme and passes its decoded pathname to fs.copyFileSync. The renderer also controls downloadPath, which determines the destination path. A compromised renderer can therefore copy any file readable by the StreamBERT process into an attacker-chosen writable location, exposing sensitive local data, and can overwrite existing writable files. This vulnerability is fixed in 2.5.0. |
| Buffer overflow in PCMan's FTP Server 2.0.7 allows remote attackers to execute arbitrary code via a long string in a USER command. |
| A vulnerability was found in PCMan FTP Server 2.0.7 and classified as problematic. This issue affects some unknown processing of the component STOR Command Handler. The manipulation leads to denial of service. The attack may be initiated remotely. The exploit has been disclosed to the public and may be used. The associated identifier of this vulnerability is VDB-251555. |
| A vulnerability was found in PCMan FTP Server 2.0.7. It has been classified as problematic. This affects an unknown part of the component USER Command Handler. The manipulation leads to denial of service. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. The associated identifier of this vulnerability is VDB-250719. |
| A vulnerability has been found in PCMan FTP Server 2.0.7 and classified as critical. This vulnerability affects unknown code of the component NLST Command Handler. The manipulation leads to buffer overflow. The attack can be initiated remotely. The exploit has been disclosed to the public and may be used. |
| Directory traversal vulnerability in PCMan's FTP Server 2.0.7 allows remote attackers to read arbitrary files via a ..// (dot dot double slash) in a RETR command. |
| A vulnerability has been found in PCMan FTP Server 2.0.7 and classified as problematic. This vulnerability affects unknown code of the component PUT Command Handler. The manipulation leads to denial of service. The attack can be initiated remotely. The exploit has been disclosed to the public and may be used. VDB-251554 is the identifier assigned to this vulnerability. |
| A vulnerability classified as critical was found in PCMan FTP Server 2.0.7. This vulnerability affects unknown code of the component PLS Command Handler. The manipulation leads to buffer overflow. The attack can be initiated remotely. The exploit has been disclosed to the public and may be used. |
| Buffer overflow in PCMan FTP Server 2.0.7 allows for remote code execution via the APPE command. |
| The SAML Single Sign On WordPress plugin before 5.4.7 does not verify the signature of a SAML response before storing the certificate it carries, and offers an administrator a one-click control that promotes that stored certificate to the site's trusted signing certificate, allowing unauthenticated attackers to have a certificate of their own trusted and then authenticate as any user, including an administrator. |
| The WPS Bidouille WordPress plugin before 1.33.5 does not have proper authorisation checks in an AJAX action, allowing any authenticated user, such as a subscriber, to retrieve the email addresses of all registered users. |
| The KiviCare WordPress plugin before 4.5.4 does not verify that the requesting user is entitled to the media file being served, allowing authenticated patient-level users to download any file in the media library, including other patients' uploaded medical reports. |
