| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: bound the pairwise-cipher OUI walk to the IE length
mwifiex_search_oui_in_ie() reads a pairwise-cipher (PTK) count from a
beacon/probe-response RSN or WPA information element and then walks that
many 4-byte OUIs, comparing each with memcmp(). The count comes straight
from the (attacker-supplied) IE and is never checked against the
element's own length, and the callers admit the element on element_id
alone (has_ieee_hdr() / has_vendor_hdr(), no length check). A crafted
RSN/WPA IE with a large pairwise count therefore makes the walk read up
to 255 * 4 bytes past the element -- an out-of-bounds read of the
kmemdup()'d beacon buffer, reachable from any AP whose beacon/probe
response is processed during scan-result parsing.
Pass the number of IE bytes available at the OUI list and bound the walk
to the element. Keep the length signed and reject a negative value
before any unsigned arithmetic, so a small or zero IE length cannot
underflow to a large size_t and defeat the bound.
Found by 0sec automated security-research tooling (https://0sec.ai). |
| An incorrect buffer size calculation vulnerability exists in tinyexpr commit 4a7456e in new_expr(). For arity-0 expression nodes, including constants, variables, and zero-argument functions, the function allocates less memory than sizeof(te_expr) but treats the returned allocation as a complete te_expr object. This results in undefined behavior and can cause deterministic process termination in UBSan-instrumented builds. |
| ZBar commit 2ea2ca58 contains an undefined-behavior vulnerability in the Code 128 decode6() function. When processing specially crafted Code 128 input, decode_e() can return -1 for an invalid edge pattern, and decode6() subsequently left-shifts this negative signed value while constructing the edge signature. The operation invokes undefined behavior and can terminate trap-mode UBSan builds with SIGILL, resulting in denial of service. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: mcast: use copy-on-write RCU updates in ip6_mc_source()
pmc->sflist is read locklessly under rcu_read_lock() by
inet6_mc_check() during packet reception in the UDP and RAW
multicast receive paths.
ip6_mc_source() mutated psl->sl_addr and psl->sl_count in-place
when adding or removing a source filter. Additionally, when expanding
the filter buffer, newpsl was published via rcu_assign_pointer()
before writing the new source into the array.
Because 16-byte struct in6_addr writes are not atomic and array
shifting is not synchronized with RCU readers, concurrent readers in
inet6_mc_check() could read torn IPv6 addresses or observe
duplicated/missed source entries.
Fix this by switching ip6_mc_source() to copy-on-write RCU updates:
allocate and fully populate newpsl before publishing it via
rcu_assign_pointer(), and reclaim the old filter via kfree_rcu(),
matching ip6_mc_msfilter().
Also remove the now unused IP6_SFBLOCK macro. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: mesh: release the channel if start fails
ieee80211_join_mesh() acquires a channel context and then calls
ieee80211_start_mesh(), which can fail. In that case, the chanctx
isn't released then interface removal will attempt to unassign it
after it's removed from the driver, hitting:
wlan0: Failed check-sdata-in-driver check, flags: 0x0
WARNING: net/mac80211/driver-ops.c:366 at drv_unassign_vif_chanctx
ieee80211_assign_link_chanctx
__ieee80211_link_release_channel
ieee80211_link_release_channel
ieee80211_teardown_sdata
unregister_netdevice_many_notify
_cfg80211_unregister_wdev
ieee80211_remove_interfaces
ieee80211_unregister_hw
mac80211_hwsim_del_radio
hwsim_exit_net
Correctly release the channel on start failures. |
| deeptutor 1.4.0 contains an authorization bypass through a user-controlled object identifier in TurnRuntimeManager.regenerate_last_turn. A remote caller can enumerate or obtain a session_id and trigger regenerate on another user's session. |
| An issue in dormakaba evolo Service (all versions) allows a remote attacker to execute arbitrary code as SYSTEM via a .NET component. |
| An issue in geelen mcp-remote 0.1.18 through 0.1.38 allows a remote attacker to obtain sensitive information via the SSE transport eventSourceInit fetch wrapper " src/lib/utils.ts |
| Oracle VM VirtualBox before 7.2.8 allows guest OS users to cause an out-of-bounds write in the host OS in pcnetReceiveNoSync in DevPCNet.cpp in the PCNet (Am79C970A) network device model. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: mxl862xx: disable the stats poll on teardown
mxl862xx_setup() arms the stats poll before mxl862xx_setup_mdio(), and
nothing stops it until dsa_register_switch() has returned an error to
mxl862xx_probe(). DSA frees the dsa_port list before it returns, so a
poll that fires once .setup or a later step of dsa_tree_setup() has
failed walks freed ports. On shutdown the user ports stay registered,
and the WORK_STOPPED flag test in mxl862xx_get_stats64() is not atomic
with the cancel in mxl862xx_shutdown(), so a re-arm that read the flag
before it was set queues the poll after cancel_delayed_work_sync() has
returned.
Arm the poll once .setup has succeeded and stop it from a .teardown op,
which DSA calls on unregister and after a failed registration, in both
cases before it frees the ports. Use disable_delayed_work_sync() there
and in shutdown(): it drains a running poll as the cancel did and turns
every later attempt to queue the work into a no-op, so the re-arm
cannot bring the poll back. remove() and the probe error path only set
WORK_STOPPED, which crc_err_work tests before it walks the ports. |
| A reachable assertion vulnerability exists in the Matter SDK (connectedhomeip) before 1.4.2, specifically within the Level Control cluster's periodic server tick logic. When a MoveToLevel command is sent and immediately followed by a write of OperationMode=2 (in the Pump Configuration and Control cluster), the server tick function violates the assertion `currentLevel < maxLevel`, resulting in a crash. This can be exploited remotely without authentication to cause denial of service. Affected versions include 1.3 and 1.4 (commit ab3d5ae). |
| In the Linux kernel, the following vulnerability has been resolved:
clk: scpi: bound-check DVFS index in scpi_dvfs_recalc_rate
dvfs_get_idx() may return an out-of-range index if the SCP firmware is
buggy or returns a stale value. Only negative indexes were rejected, so a
large index walked past info->opps and could treat garbage as a clock rate
(KASAN OOB / wrong frequency to consumers). The missing upper bound dates
back to the original SCPI clock driver.
Treat indexes >= opp count as invalid and return 0, same as idx < 0. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: iptfs: fix runt reassembly panic from short inner tot_len
When the start of an inner packet is split across two outer packets
such that fewer than 4 bytes land at the end of the first one,
__input_process_payload() saves those bytes as a runt and skips the
iplen/iphlen validation performed for in-place packets. When the
continuation packet arrives, iptfs_reassem_cont() only requires the
declared inner length to be >= sizeof(ra_runt) (6) before allocating
the reassembly skb with that attacker-controlled length.
However, __iptfs_iphlen() always returns the fixed minimum IP header
size (20 for IPv4, 40 for IPv6), so for an inner IPv4 tot_len in
[6, 19] the header-completion copy writes past the declared packet
length, and the subsequent "ipremain -= copylen" underflows to ~4GB,
leaving the payload copy length bounded only by blkoff (up to 64KB).
At runtime the skb_put() tailroom check turns this into
skb_over_panic(), i.e. an unprivileged kernel panic (DoS), reachable
locally via userns+netns IPTFS SAs and remotely against IPTFS VPN
gateways when the decrypted outer skb is linear (e.g. AF_PACKET taps,
tun/tap delivery).
Align the runt path with the normal path by requiring the declared
inner length to cover at least the IP header size. This also subsumes
the previous >= sizeof(ra_runt) check, since the minimum IP header
is always larger than the runt buffer.
This issue was found by the autokbug dynamic kernel fuzzer at
Tencent Yunding Lab. |
| Smarty before 4.5.8 and 5.x before 5.8.5 contains a code injection vulnerability where the top-level nocache_hash is never restored during extends:/multi-component template inheritance, leaving it null. Attackers can supply assigned data containing a forged SmartyNocache marker that is copied verbatim into the regenerated PHP cache file, executing arbitrary PHP on include for remote code execution. |
| In the Linux kernel, the following vulnerability has been resolved:
phy: fsl-imx8mq-usb: fix typec switch leak on probe error path
If probe fails after imx95_usb_phy_get_tca() succeeds, the typec
switch leaks because the only cleanup path was in .remove(), which
never runs on probe failure.
Use devm_add_action_or_reset() so the switch is cleaned up on both
probe failure and driver removal. The imx95_usb_phy_put_tca() is no
longer needed, it will be removed in .remove() too. |
| Information leak in SVG in Google Chrome prior to 154.0.8037.97 allowed a remote attacker to obtain sensitive information via a crafted HTML page. (Chromium security severity: Medium) |
| In the Linux kernel, the following vulnerability has been resolved:
rds: ib: use rds_conn_drop() on protocol version mismatch
rds_ib_cm_connect_complete() runs from the RDMA-CM event handler with
conn->c_cm_lock held. When the peer negotiates a protocol version
older than RDS_PROTOCOL_COMPAT_VERSION, the handler calls
rds_conn_destroy(), which is only safe in the rmmod path: it
synchronously tears the connection down and flush_work()es the
shutdown work cp_down_w.
That shutdown work (rds_conn_shutdown()) needs cp_cm_lock, which is
the very lock the event handler still holds, so the flush never
completes: the two workers wait on each other and the RDS connection
workqueues stall for good.
All other RDMA-CM failure paths (REJECTED, CONNECT_ERROR,
DISCONNECTED) use rds_conn_drop(), which marks the connection
RDS_CONN_ERROR and schedules the shutdown work asynchronously. Use
it here as well. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix out-of-bounds read in P2P public action frames
wilc_wfi_p2p_rx() and mgmt_tx() start parsing a frame once
ieee80211_is_public_action() returns true. That helper only verifies the
frame is long enough for the action category field, that is
offsetofend(struct ieee80211_mgmt, u.action.category), 25 bytes. Both
functions then read the P2P public action header up to oui_subtype at
offset 30 and pass "size - ie_offset" to cfg80211_find_vendor_ie(), where
ie_offset is offsetof(struct ieee80211_mgmt, u) + sizeof(*d), i.e. 32.
A public action frame of 25 to 31 bytes passes the check but is shorter
than that 32 byte header, so oui_subtype can be read out of bounds, and
because the length is unsigned, "size - ie_offset" underflows to a value
close to 4 GiB. cfg80211_find_vendor_ie() takes an unsigned int length,
so even the size_t subtraction in mgmt_tx() is truncated to the same
value. It then walks far past the buffer searching for a vendor element
until it reaches unmapped memory.
In the receive path the frame arrives over the air and needs no
association, so a nearby unauthenticated device can crash the host while
it is in P2P listen. Reject frames shorter than the P2P public action
header in both paths before dereferencing it. |
| In the Linux kernel, the following vulnerability has been resolved:
IB/mlx4: Fix use-after-free on pkey sysfs registration failure
register_pkey_tree() ignores errors from register_one_pkey_tree() and
continues registering the remaining slaves. The per-slave error path has
already released the pkey parent kobjects, but their pointers remain
stored in the device. A later device cleanup therefore passes the stale
pointers to kobject_put(), causing a use-after-free.
Clear the parent pointers after releasing a failed slave tree and skip
unregistered trees during device cleanup. This preserves the existing
best-effort registration behavior while preventing a second cleanup of
the failed tree. |
| In the Linux kernel, the following vulnerability has been resolved:
arm64: hibernate: pass HVC_SET_VECTORS args to the resume hvc
swsusp_arch_suspend_exit() reinstalls the restored kernel's hyp stub
vectors with an hvc, but never passes the arguments. x0 is not set to
HVC_SET_VECTORS and x1 is not set to the vector address, so the stub
dispatch falls through and returns without writing vbar_el2. EL2 is
left pointing at the trans_pgd copy of the vectors, a page that
swsusp_free() releases right after resume.
Set the arguments up the same way __hyp_set_vectors() does.
Without this fix, Vladimir was able to trigger a hang when resuming from
hibernation with CONFIG_PAGE_POISONING=y and page_poison=on. |
