| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: cake: reject overhead values that underflow length
CAKE accepts signed overhead values and stores them in an s16, but the
adjusted packet length calculation uses unsigned arithmetic. A negative
effective length can therefore wrap to a large value.
Such configurations make rate accounting depend on integer wraparound
rather than on the packet size userspace intended to model. A static
netlink lower bound is not enough because packets reaching CAKE can be
smaller than any reasonable manual-overhead allowance.
Fold the signed overhead adjustment into the existing datapath MPU clamp
so negative adjusted lengths are clamped before link-layer framing
adjustments. |
| In the Linux kernel, the following vulnerability has been resolved:
perf/x86/amd/core: Avoid enabling BRS from the SVM reload path
Branch Sampling (BRS) and Last Branch Record (LBR) are mutually
exclusive hardware features, and users of both are tracked via
cpuc->lbr_users.
When SVM is toggled on a CPU, the host perf events are reprogrammed to
update the HostOnly filter bit (set when virtualization is enabled,
cleared when it is disabled). On PerfMonV2-capable processors, this
reprogramming is performed by calling amd_pmu_enable_all() to rewrite
the event selectors. However, amd_pmu_enable_all() also calls
amd_brs_enable_all(), which enables BRS whenever cpuc->lbr_users > 0.
Having active LBR events satisfies this gating on processors that have
LBR but not BRS. The kernel then tries to set the BRS enable bit in
DebugExtnCfg (MSR 0xc000010f). Since that bit is deprecated on such
hardware, the write results in a #GP:
Call Trace:
<IRQ>
amd_pmu_enable_all+0x1d/0x90
amd_pmu_disable_virt+0x62/0xb0
kvm_arch_disable_virtualization_cpu+0xa/0x40 [kvm]
hardware_disable_nolock+0x1a/0x30 [kvm]
__flush_smp_call_function_queue+0x9b/0x410
__sysvec_call_function+0x18/0xc0
sysvec_call_function+0x69/0x90
</IRQ>
<TASK>
asm_sysvec_call_function+0x16/0x20
RIP: 0010:cpuidle_enter_state+0xc4/0x450
? cpuidle_enter_state+0xb7/0x450
cpuidle_enter+0x29/0x40
cpuidle_idle_call+0xf5/0x160
do_idle+0x7b/0xe0
cpu_startup_entry+0x26/0x30
start_secondary+0x115/0x140
secondary_startup_64_no_verify+0x194/0x19b
</TASK>
Fix this by ensuring that BRS is not enabled from the event selector
reprogramming path even when cpuc->lbr_users > 0. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: mvebu: free generic chips on unbind
irq_alloc_domain_generic_chips() allocates generic chip data that must
be freed via irq_domain_remove_generic_chips(). The devres action
mvebu_gpio_remove_irq_domain() only called irq_domain_remove(), which
only frees the generic chips if IRQ_DOMAIN_FLAG_DESTROY_GC is set.
Call irq_domain_remove_generic_chips() explicitly before
irq_domain_remove() instead. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv4: igmp: Fix potential memory leaks in igmp_mod_timer() and igmp_stop_timer()
When a timer is deleted and not re-armed in igmp_mod_timer(), or stopped
in igmp_stop_timer(), the code currently decrements the reference counter
of the multicast list entry @im using refcount_dec(&im->refcnt).
However, both functions can be called from the RCU reader path:
- igmp_mod_timer() via igmp_heard_query() -> for_each_pmc_rcu()
- igmp_stop_timer() via igmp_rcv() -> igmp_heard_report()
If the group im was concurrently removed from the list by ip_mc_dec_group(),
its reference count might have already been decremented to 1.
In this case, timer_delete() succeeds, and refcount_dec() decrements
the refcount from 1 to 0. Since refcount_dec() does not free the object
when it hits 0 (unlike ip_ma_put()), the im structure is leaked.
Fix this by using ip_ma_put(im) instead of refcount_dec(&im->refcnt),
and deferring the put until after the spinlock is released. |
| In the Linux kernel, the following vulnerability has been resolved:
dm era: fix NULL pointer dereference in metadata_open()
metadata_open() returns NULL when kzalloc_obj() fails, but the
caller era_ctr() only checks IS_ERR(md). Since IS_ERR(NULL)
returns false, the NULL pointer is treated as a valid result
and later assigned to era->md, leading to a NULL pointer
dereference when the metadata is accessed.
Fix this by returning ERR_PTR(-ENOMEM) on allocation failure,
consistent with dm-cache-metadata.c, dm-thin-metadata.c, and
dm-clone-metadata.c which all use ERR_PTR(-ENOMEM) for the
same pattern. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/fb-helper: Only consider active CRTCs for vblank sync
Only synchronize fbdev output to the vblank of an active CRTC. Go over
the list of CRTCs and pick the first that matches. Fixes warnings as
the one shown below
[ 77.201354] WARNING: drivers/gpu/drm/drm_vblank.c:1320 at drm_crtc_wait_one_vblank+0x194/0x1cc [drm], CPU#1: kworker/1:7/1867
[ 77.201354] omapdrm omapdrm.0: [drm] vblank wait timed out on crtc 0
This currently happens if the fbdev output is not on CRTC 0.
Atomic and non-atomic drivers require distinct code paths. As for other
fbdev operations, implement both and select the correct one at runtime.
Not finding an active CRTC is not a bug. Do not wait in this case, but
flush the display update as before.
v4:
- avoid possible deadlocks with locking context (Sashiko)
v3:
- drop excessive state validation (Jani)
- acquire plane and CRTC mutices (Sashiko)
v2:
- move look-up code into separate helper
- support drivers with legacy modesetting
v1:
- see https://lore.kernel.org/dri-devel/1c9e0e24-9c4a-4259-8700-cf9e5fd60ca3@suse.de/ |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe: free madvise VMA array on L2 flush failure
xe_vm_madvise_ioctl() allocates madvise_range.vmas in get_vmas().
After get_vmas() succeeds with at least one VMA, error paths must go
through free_vmas so the array is released before the madvise details are
destroyed.
The L2 flush validation path added for PAT madvise rejects some
SVM/userptr ranges after get_vmas() has succeeded, but jumps directly to
madv_fini. This skips kfree(madvise_range.vmas), leaking the VMA array on
each failed ioctl.
Jump to free_vmas instead, matching the other validation failure paths
after get_vmas() has succeeded.
(cherry picked from commit c3a1c3579b1250060da73507a4acef712974c78a) |
| In the Linux kernel, the following vulnerability has been resolved:
tracing/remotes: Fix leak in trace_remote_alloc_buffer() error path
If page allocation fails in trace_remote_alloc_buffer(), desc->nr_cpus
is not yet incremented for the current CPU. As a consequence, on error,
half-allocated rb_desc will not be freed in trace_remote_free_buffer().
Increment desc->nr_cpus as soon as the first allocation for the current
CPU has succeeded. |
| In the Linux kernel, the following vulnerability has been resolved:
mlxsw: fix refcount leak in mlxsw_sp_vrs_lpm_tree_replace()
When mlxsw_sp_vrs_lpm_tree_replace() fails after replacing some VRs,
the error rollback loop does not correctly revert the preceding
replacements. The loop decrements the index but fails to update the
vr pointer, which still points to the VR that caused the failure. As
a result, the condition and the rollback call always operate on the
same VR, potentially calling mlxsw_sp_vr_lpm_tree_replace() multiple
times on it while never rolling back the earlier VRs. Those VRs
continue to hold a reference to new_tree acquired via
mlxsw_sp_lpm_tree_hold(), leaking the reference count of new_tree.
Fix by reinitializing vr inside the error loop with the updated index:
vr = &mlxsw_sp->router->vrs[i];
so that the loop correctly iterates over all VRs that were actually
replaced. |
| In the Linux kernel, the following vulnerability has been resolved:
VDUSE: avoid leaking information to userspace
The bounceing is not necessarily page aligned, so current VDUSE can
leak kernel information through mapping bounce pages to
userspace. Allocate bounce pages with __GFP_ZERO to avoid leaking
information to userspace. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: vsie: Add missing radix_tree_preload() in _gaccess_shadow_fault()
Add missing radix_tree_preload() in _gaccess_shadow_fault() to
guarantee forward progress. The core of _gaccess_shadow_fault() has
been split into ___gaccess_shadow_fault() in order to simplify locking. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Initialize KVM_S390_GET_CMMA_BITS memory
kvm_s390_get_cmma_bits() allocates its output buffer with vmalloc(),
which does not zero the returned pages:
values = vmalloc(args->count);
In the non-peek (migration) path, dat_get_cmma() reports a byte count
spanning from the first to the last dirty page, but __dat_get_cmma_pte()
writes values[gfn - start] only for pages whose CMMA dirty bit is set.
The walk uses DAT_WALK_IGN_HOLES, so clean and unmapped pages that lie
between two dirty pages within the reported span are visited but never
store their byte. Those gaps (up to KVM_S390_MAX_BIT_DISTANCE pages
each) stay uninitialized yet fall inside [0, count) and are copied out
by copy_to_user(), disclosing stale kernel memory to user space.
Before the switch to the new gmap implementation the buffer was fully
populated for every gfn in the span, so no uninitialized bytes were
exposed; the dirty-only walk introduced the leak.
Use vzalloc() so the gaps read back as zero. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: metronomefb: fix potential memory leak in metronomefb_probe()
The memory allocated for pagerefs in fb_deferred_io_init() is not freed
on the error path. Fix it by calling fb_deferred_io_cleanup(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: broadsheetfb: fix potential memory leak in broadsheetfb_probe()
The memory allocated for pagerefs in fb_deferred_io_init() is not freed
on the error path. Fix it by calling fb_deferred_io_cleanup(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: hecubafb: fix potential memory leak in hecubafb_probe()
The memory allocated for pagerefs in fb_deferred_io_init() is not freed
on the error path. Fix it by calling fb_deferred_io_cleanup(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: efifb: fix memory leak in efifb_probe()
Since commit 73ce73c30ba9 ("fbdev: Transfer video= option strings to
caller; clarify ownership") the string returned from fb_get_options()
is expected to be freed by the caller, but the string is not freed in
efifb_probe(). Fix that by freeing the option string after setup. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: radeon: fix potential memory leak in radeonfb_pci_register()
The function radeonfb_pci_register() allocates memory for modelist
(by calling radeon_check_modes() which calls fb_add_videomode()).
The memory is appended to info->modelist, but is not freed in subsequent
error paths. Fix this by calling fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: s3fb: fix potential memory leak in s3_pci_probe()
In s3_pci_probe(), the memory allocated for modelist using
fb_videomode_to_modelist() is not freed in subsequent error paths.
Fix that by calling fb_destroy_modelist() |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: tdfxfb: fix potential memory leak in tdfxfb_probe()
In tdfxfb_probe(), the memory allocated for modelist using
fb_videomode_to_modelist() when CONFIG_FB_3DFX_I2C is defined, is not
freed in the subsequent error paths.
Fix that by calling fb_destroy_modelist(). |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: carminefb: fix potential memory leak in alloc_carmine_fb()
The memory allocated for modelist in fb_videomode_to_modelist() is not
freed in the subsequent error path.
Fix that by calling fb_destroy_modelist() |
