| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
regulator: fp9931: Fix VPOS/VNEG voltage selector table
The VPOSNEG_table[] mapping does not match the FP9931 datasheet.
The datasheet defines the VPOS/VNEG voltage mapping as:
00h-04h -> 7.04V (-7.04V)
05h -> 7.26V (-7.26V)
06h -> 7.49V (-7.49V)
...
28h-3Fh -> 15.06V (-15.06V)
However, VPOSNEG_table[] has two issues:
1. Selector 0x00~0x04 should all map to 7.04V (5 entries), but the
table has 6 entries of 7.04V, causing all subsequent entries to be
shifted by one position.
2. Selectors 0x29~0x3F should all clamp to 15.06V (23 entries), but
the table has only 41 entries. Any selector value above 0x28
would result in an out-of-bounds table access.
Fix both issues by removing the duplicate 7.04V entry and appending
the missing 23 clamped 15.06V entries, bringing the table to the
correct size of 64 entries (0x00~0x3F). |
| In the Linux kernel, the following vulnerability has been resolved:
ovpn: ensure socket is owned by ovpn before deref sk_user_data
Some subsystems, like BPF SOCKMAP, set sk_user_data without
actually setting the encap_type.
For this reason, we must make sure that the type is the
one ovpn expects before dereferencing sk_user_data.
Failing to do so may lead to out-of-bounds reads. |
| In the Linux kernel, the following vulnerability has been resolved:
mmc: loongson2: Fix sg iteration in data reorder functions
In ls2k0500_mmc_reorder_cmd_data() and ls2k2000_mmc_reorder_cmd_data(),
the for_each_sg() macro already iterates over the scatterlist entries,
with 'sg' pointing to the current entry. However, the code incorrectly
uses '&sg[i]' and 'sg_dma_len(&sg[i])' inside the loop, which treats
'sg' as an array base and indexes it again, leading to access of
wrong sg entries (or out-of-bounds if the list is not an array). |
| In the Linux kernel, the following vulnerability has been resolved:
pmdomain: mediatek: fix remaining %pOF after of_node_put()
scpsys_get_bus_protection_legacy() looks up several legacy bus
protection regmaps from device-tree nodes.
Two error paths put the device node before checking whether the regmap
lookup failed, but still pass that node to dev_err_probe() with %pOF on
failure. If of_node_put() drops the last reference, the later %pOF
formatting can dereference a freed device node.
Keep the node reference until after the error message has been emitted in
the infracfg and SMI lookup paths. Also drop the SMI node before
returning when the SMI phandle is missing. |
| Improper Neutralization of Special Elements used in an SQL Command ('SQL Injection') vulnerability in Firmanet Software ERP allows SQL Injection.
This issue affects ERP: before 15.0.1. |
| In the Linux kernel, the following vulnerability has been resolved:
pmdomain: mediatek: mfg: initialize prev_o in mtk_mfg_attach_dev()
mtk_mfg_attach_dev() reads prev_o on the first iteration of its loop,
in "if (prev_o && prev_o->freq == o->freq)", before prev_o is assigned
at the end of the loop body. On that first iteration, evaluating prev_o
reads an indeterminate value. If it is non-NULL, the condition
dereferences a stale or invalid pointer, potentially faulting or
incorrectly skipping the first OPP.
Initialize prev_o to NULL. This matches the intent as well: there is no
previous OPP to compare against on the first iteration.
Found with Clang's -Wconditional-uninitialized. |
| A flaw was found in Keycloak. When the logging format is configured to a verbose, user-supplied pattern (such as the pre-defined 'long' pattern), sensitive headers including Authorization and Cookie are disclosed to the logs in cleartext. An attacker with read access to the log files can extract these credentials (e.g., bearer tokens, session cookies) and use them to impersonate users, leading to a full account compromise. |
| In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Fix bandwidth group reservation indexing
Valid bandwidth group IDs range from 1 through MAX_GROUPS, while Group
ID 0 is reserved. tb_consumed_dp_bandwidth() uses the Group ID directly
to index its local group_reserved[] array.
The array currently has MAX_GROUPS entries, so its valid indices are 0
through MAX_GROUPS - 1. Group ID MAX_GROUPS therefore accesses one
element past the end, and the final group's reserved bandwidth is not
included when the array is summed.
Give group_reserved[] MAX_GROUPS + 1 entries so direct Group ID
indexing covers the reserved ID 0 and valid IDs 1 through MAX_GROUPS. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/log: Fix out-of-bounds read on empty message length
drm_log_draw_kmsg_record() accesses s[len - 1] to strip the trailing
newline, but len is unsigned int. If len is 0, the subtraction wraps
to UINT_MAX, causing an out-of-bounds read.
Add an early return when len is 0. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/connector/hdmi: Fix out of bounds memory read
A helper function was copying a given audio infoframe into the
connector's copy but using the size of the destination (a generic
target, sized to accept many different data blocks) not the source (a
very specific type of data block). Thus, it was copying 60 bytes of
data from a 28 byte allocation.
Fix that by using the source size instead, together with a build bug
on the source size actually being smaller than the destination.
I hit this running KUnit tests under KASAN (while debugging something
else entirely). In the real world, it seems unlikely to cause an
actual problem. It is a read not a write so it can't corrupt any
memory. However, it could potentially fall off the end of a page and
cause an accvio bug. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: psxpad-spi - set driver data before use
psxpad_spi_suspend() retrieves the controller state with
spi_get_drvdata(), but probe never stores it, so suspend dereferences a
NULL pointer. Store it during probe. |
| Red Hat Product Security has come to the conclusion that this CVE is false due to upstream security policy. |
| Tencent AI-Infra-Guard's skill-scan component excludes compiled Python bytecode files from analysis by hardcoding __pycache__ directories and .pyc/.pyo/.pyd extensions into skip lists across multiple scanning surfaces. Attackers can distribute skills with benign Python source files alongside malicious compiled bytecode that executes on import while the scanner reports a safe verdict, enabling code execution when operators install the skill. |
| Kimai before 2.65.0 fails to properly validate permissions when removing team access to activities, projects, and customers via API endpoints. Authenticated users with edit_team permission can revoke team access without the required permissions_activity check, bypassing authorization controls. |
| Craft CMS before 5.11.0 fails to enforce user-group scope filters on native GraphQL user relations including author, authors, uploader, draftCreator, and revisionCreator fields. Attackers with a scoped GraphQL token can query these relations to read usernames, email addresses, and full names of any content author or uploader including administrators. |
| Craft CMS versions before 5.10.11 lack authorization checks in the assets/move-asset endpoint when force=1 is supplied. Authenticated users without peer asset permissions can move their own assets into other users' folders and force deletion of conflicting files, allowing unauthorized asset deletion and replacement. |
| Unauthenticated Denial of Service Attack in WP Go Maps <= 10.1.08 versions. |
| Unauthenticated Cross Site Request Forgery (CSRF) in Simply Schedule Appointments <= 1.6.12.23 versions. |
| PX4 Autopilot contains a heap buffer overflow vulnerability in the sd_bench command that writes a four-byte block number into a user-supplied sized allocation. Attackers can invoke sd_bench with a block size below four bytes to overflow the heap buffer and potentially execute code or crash the system. |
| ION-DTN versions before 4.2.0 contain an out-of-bounds read vulnerability in the decodeSdnv function that allows unauthenticated remote attackers to read memory by sending truncated SDNV values. Attackers can send a UDP datagram to the LTP link service input port with a truncated SDNV to trigger reads up to nine bytes past buffer boundaries and underflow byte counters. |
